E-flite EFLG110 Spécifications télécharger pdf

10- to 15-Size

Electric Retract

Instructions

Thank you for purchasing the E-ite

10- to 15-Size

Electric Retracts. These self-contained units are

powered from your model’s receiver and do not require

separate servos.

The retracts are supplied with coil struts installed, plus

adjustable axles, wheel collars, Allen wrenches and a

3-into-1 wire harness (for the tricycle set) or 2-into-1

wire harness (for main gear set). The nose gear unit is

steerable and has a slot in the sliding steering arm to

prevent binding of the steering cable when retracted.

Specications

Current draw

Idle 5mA

Operating 150mA (maximum)

Pulse width trigger points

Down 1.331ms

Up 1.690ms

Operation with FM and DSM

FM 22ms frame rate, 5V signal

DSM 20ms frame rate, 3.3V signal

Sequence time

@ 4.8V 1.25sec

@ 6.0V 1sec

@7.4V 0.8sec

Operating voltage range 4.8 – 7.4V

Aircraft weight: 2.0 - 4.5 lb (0.9 – 2.0 kg)

Unit weight: Nose gear 1.6 oz (45 g)

Main gear 1.3 oz (37 g) each

Parts Available

EFLG101 10 - 15 Main Electric Retract Unit

EFLG102 10 - 15 Left Main Wire Strut

EFLG103 10 - 15 Right Main Wire Strut

EFLG104 10 - 15 Adjustable Axles

EFLRYH9 10 - 15 Dual Plug Y-harness

EFLG111 10 - 15 Nose Electric Retract Unit

EFLG112 10 - 15 Nose Gear Wire Strut

EFLG113 10 - 15 Nose Gear Steering Arm

EFLRYH9TR 10 - 15 Triple Plug Y-harness

Tools Required

Pencil Screwdriver

1.5mm hex wrench 2.5mm hex wrench

Flat le Threadlock

Rotary tool with cutoff wheel

Installation

1. Test t the retract unit in the wing or fuselage to

determine the strut length and axle location. Cut the

strut to length using a cutoff wheel in a rotary tool.

2. Make two at spots on the end of the strut with a le

and use a 2.5mm hex wrench to secure the axle to the

strut. Apply threadlock to the threads of the retaining

screws so they do not loosen from vibration.

EFLG100

EFLG110

1 2 3 4

Résumé du contenu

Page 1 - Instructions

10- to 15-Size Electric RetractInstructionsThank you for purchasing the E-ite® 10- to 15-Size Electric Retracts. These self-contained units are power

Page 2

3. Install the wheels on the axles. Slide the brass wheel collar onto the axle and secure it using a 1.5mm hex wrench. Apply threadlock to the setscre

Page 3 - Warranty Information

Warranty InformationWarranty PeriodExclusive Warranty- Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “Product”) will be f

Page 4 - Declaration of Conformity

United States:Electronics and engines requiring inspection or repair should be shipped to the following address:Horizon Service Center4105 Fieldstone