E-flite EFL7150 Manuel d'instructions télécharger pdf (Page 15)

Problem Possible Cause Solution

Oscillation

Flying too fast in 3D mode Change to Precision Mode

Flying over recommended

airspeed

Reduce air speed

Damaged propeller or spinner Replace propeller or spinner

Imbalanced propeller

Balance the propeller. For more information, view John Redman’s propeller balancing video at www.

horizonhobby.com

Motor vibration Replace parts or correctly align all parts and tighten fasteners as needed

Loose receiver Align and secure receiver in fuselage

Loose aircraft controls Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)

Worn parts Replace worn parts (especially propeller, spinner or servo)

Irregular servo movement Replace servo

Trim change

when ﬂ ight

mode is switched

Receiver did not save trim After adjusting transmitter trim in the air or on the ground, do not touch the control sticks for 2 seconds

Incorrect response

to the AS3X Control

Direction Test

Incorrect direction settings in

the receiver, which can cause

a crash

DO NOT ﬂ y. Correct the direction settings (refer to the receiver manual), then ﬂ y

Troubleshooting Guide SAFE

Power Component Service

CAUTION: Always disconnect the ﬂ ight battery before performing

motor service.

Disassembly

1. Remove the screw (A) and spinner (B) from the collet (G).

2. Remove the spinner nut (C), propeller (D), backplate (E) and collet from the

motor shaft (H). You will need a tool to turn the spinner nut.

3. Remove 3 screws (I) from the cowling (J). Carefully remove the cowling

from the fuselage. Paint may keep the cowling attached to the fuselage.

4. Remove the 4 screws (K) from the motor mount (L) and the fuselage.

5. Disconnect the motor wires from the ESC wires.

6. Remove the 4 screws (M) and motor (N) from the motor mount.

Assembly

Assemble in reverse order.

• Correctly align and connect the motor wire colors with the ESC wires.

• The propeller size numbers (12 x 4) must face out from the motor for correct

propeller operation.

• A tool is required to tighten the lock nut on the collet.

Not all wiring shown.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire

E-flite EFL7150 Manuel d'instructions Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Jouets télécommandés E-flite EFL7150