E-flite Apprentice 15e PNP Spécifications télécharger pdf (Page 15)

15E-flite Apprentice PNP Assembly Manual

CHECKING THE RUDDER (MODE 1 AND 2)

 6. Mode 1 (Rudder/Elevator on left stick): Center

the rudder stick. Thread the clevis in or out on the

rudder pushrod until the rudder is aligned with the

fin as shown.

Mode 2 (Rudder/Throttle on left stick): Confirm the

rudder stick is in the down/throttle off position.

Thread the clevis in or out on the rudder pushrod

until the rudder is aligned with the fin as shown.

Centered

Right—Thread clevis out

Left—Thread clevis in

 7. Check the movement of the rudder using the

transmitter. When the rudder/throttle stick (left side

of the transmitter) is moved right, the rudder should

also move right.

When operating a Mode 2 transmitter (rudder/

throttle on left stick), be very careful that the

left stick is not moved forward when checking

the rudder. Moving the rudder stick forward

will result in the propeller spinning.

 8. Check the movement of the rudder using the

transmitter. When the left stick is moved left, the

rudder should also move left.

CHECKING THE STEERING TRIM (MODE 1 AND 2)

Checking the steering trim must be done after the

aircraft has been flown and the rudder trimmed for

straight flight at the transmitter. The steering trim

is a mechanical adjustment and should never be

corrected using the rudder trim at the transmitter.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Pas de commentaire

E-flite Apprentice 15e PNP Spécifications Page 15