E-flite Blade mSR BNF Manuel d'instructions télécharger pdf (Page 12)

22 23

If you decide to use an E-flite LP5DSM or HP6DSM transmitter, please position your

channel reversal dip switches as follows:

LP5DSM Transmitter HP6DSM Transmitter

Note: Keep a record of the existing settings in case you want to go back and fly

your other aircraft.

Once you’ve reconfirmed the flight control directions, all controls should be

functioning properly. However, if you continue to encounter any problems with

your Blade mSR responding properly to the transmitter, do not fly. Call the Horizon

Support Team at 1-877-504-0233.

If you’ve confirmed proper control operation of your Blade mSR, continue reading the

manual prior to attempting to fly the helicopter.

Note: Attempting to fly the helicopter without completely reading the manual may

cause injury to yourself and people in the vicinity, as well as damage to

the helicopter.

Important Channel 5 Information

•Channel5affectsratesettingsofthe5-in-1ControlUnit.

•IfusingtheMLP4DSMTransmitter,thisinformationisnotpertinent.

•IfusinganLP5DSMorHP6DSMTransmitter,pleaseturntheChannel5knob

clockwise completely.

•IfusingaDSM2compatibletransmitter,pleaseensureChannel5issettodefault

servo reversal and the switch or knob is set to a position that allows full travel

control.

Note: This can easily be tested by inducing full cyclic (Aileron/Elevator) input and

moving the switch or knob. There’s approximately 15% less or more servo

travel depending on what position Channel 5 is in.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Pas de commentaire

E-flite Blade mSR BNF Manuel d'instructions Page 12