Instruction ManualBedienungsanleitungManuel d’utilisationManuale di IstruzioniCARBON-Z YAK 54
ENInstalling the Flight BatteryNote: Before flying and after centering control surfaces, rebind the aircraft so control surfaces are neutral when you
ENRemoving the Control SurfacesTo remove the control surfaces, follow the steps listed below:Elevator1. Disconnect the clevis from the control horn.
ENRemoving Propeller Adapter, Propeller and Spinner Note: The information on this page is for maintenance of the Yak 54. Spinner, propeller and prop
EN4. To install the motor:Slide the 4 motor wires through the guide holes and slide the motor all the way into the nose.Note: When installing the ne
ENNote: The Carbon-Z Yak 54 can be taken apart and put back in the box for storage or transportation.Note: The Carbon-Z Yak 54 is a high-performance a
ENTroubleshooting GuideProblem Possible Cause SolutionAircraft will not respond to throttle but responds to other controls• ESC is not armed.• Throttl
ENReplacement PartsHere is a list of replacement parts to repair or keep your Carbon-Z Yak 54 flying. These parts are available at your local hobby sh
ENWarranty and Repair PolicyWarranty PeriodExclusive Warranty- Horizon Hobby, Inc., (Horizon) warranties that the Products purchased (the “Product”) w
ENContact InformationCompliance Information for the European UnionDeclaration of Conformity (in accordance with ISO/IEC 17050-1) No. HH2010080903Pro
© 2010 Horizon Hobby, Inc.E-Flite® products are distributed exclusively by Horizon Hobby, Inc. The Spektrum trademark is used with permission of Bach
ENSafety Precautions and WarningsAs the user of this product, you are solely responsible for operating in a manner that does not endanger yourself and
ENTable of ContentsCarbon-Z Yak 54 Speci cationsWingspanLengthWeight (RTF)48 in (1220mm)48.5 in (1232mm)3.75-3.81 lb (1700-1730 g)Carbon-Z Yak 54 Fe
ENThe Battery Charging Process1. Charge only batteries that are cool to the touch and are not damaged. Look at the battery to make sure it is not dam
ENGeneral Assembly and Maintenance TipsNote: This checklist is not a replacement for the content included in this manual. Although you can use it as a
ENInstalling Landing GearNote: You may remove fairings for flying the Carbon-Z Yak 54 from a rough runway.1. Press together landing gear legs and pu
ENInstalling Wings1. Put the wing tube in the round hole in the wing slot of the fuselage.2. Put left wing on the wing tube. 3. Move the wing o
ENInstalling Horizontal Tail and Pushrods on Control HornsInstalling the Horizontal Tail1. Put the horizontal stabilizer tube in the round hole loca
Commentaires sur ces manuels